PolyForce1000e Tracked Worldpoly PolyForce1000e Tracked. Australian Made high pressure tracked butt welding machine featuring safety, speed, consistency and ease of use. Intuitive operation using modern rugged electronics providing hydraulic open/close/hands-free locking o Worldpoly PolyForce1000e Tracked. Australian Made high pressure tracked butt welding machine featuring safety, speed, consistency and ease of use. Intuitive operation using modern rugged electronics providing hydraulic open/close/hands-free locking of main clamps, hydraulic in/out of heating plate and facing tool, external pipe lifters, multiple safety-stops and operator prompts. Low-noise Yanmar diesel provides long operating hours. Two-speed rubber tracks with cordless remote control. Read More REQUEST A QUOTE SAFETY Worldpoly PolyForce1000e Tracked High-pressure butt welding machine including on-board low noise Yanmar diesel, easily operated electronic controls, hydraulically movable facing tool and heating plate, hydraulic open/close/locking of pipe clamps, stub welding device and 4 circles of two-piece clamps 1000mm to 500mm. Tracked base includes low-noise Yanmar low RPM diesel engine, external hydraulic pipe lifters, two-speed rubber tracks, wireless remote control, data logging included. Technical Specifications BROCHURE PolyForce1000e Tracked HDPE Fusion Machine - Australian Made Track mounted, self contained and self propelled Wireless remote control included as standard Hydraulic in/out facing tool and heating plate Hydraulic open/close/locking of main clamps without operator contact Yanmar on-board low-noise low fuel consumption diesel or optional Tier 4 Final Simple operation, including data logging Pipe clamps prevent slippage even under extreme conditions External hydraulic pipe lifters front and rear Long operating time thanks to engine control system and low RPM Australian made, built tough, locally serviceable, low-noise. Just what you've been looking for Capacity 500 to 1000mm OD. Two-piece clamp inserts for pipe and fittings diameters 1000, 900, 800, 710, 630, 560 & 500mm, and stub device for short-spigot stub flange fittings are included Electric start with engine management system Welded steel machine frame and tracked base Rubber track assembly is two-speed, 30+ degree capacity, automatic braking when stop Maximum pump operating pressure - 205 bar / 20 MPa / 2970 psi Weight - 6500 kg / 14300 lb., low center of gravity, Suitable for road transport without removal of welding frame. Drives into a standard container Cylinder section 12,922 mm² / 200.2 inch². Optional cylinders available with increased force, or decreased if welding thin wall pipes. Technical specifications subject to change without notice. Please check at time of order confirmation.